Installation
6
307158ZAP
Installation
Maximum Hydraulic Input Pressure
The maximum safe hydraulic input pressure to this
motor depends on the lower displacement pump to
which it is connected.
With Graco Displacement Pump Models 207474,
207655, 210208, 217527, 217339, 222796, 222801,
222803, 222805, 222810, and 222811, use a
maximum of 1500 psi (10 MPa, 103 bar) hydraulic
input pressure.
For Graco Displacement Pump Models 24B923 and
687055, usa a maximum of 1900 psi (13.1 MPa, 131
bar) hydraulic input pressure.
Never exceed 1000 psi (7 MPa, 70 bar) hydraulic
input pressure with the motor connected to any
displacement pump other than those listed above;
serious injury or damage to the equipment may
result.
To reduce the risk of serious injury whenever you are
instructed to relieve pressure, always follow the
Pressure Relief Procedure on page 8.
Be sure you always shut off the supply line shutoff
valve (E) first, and then the return line shutoff valve.
This is to prevent overpressurizing the motor or its
seals. When starting up the hydraulic system, open
the return line shutoff valve first.
NOTICE
Keep the hydraulic system clean
To reduce the risk of damaging the hydraulic power
supply, blow out all hydraulic lines with air, flush
thoroughly with solvent, and then blow out with air
again before connecting the lines to the motor.
Always plug the hydraulic inlets, outlets and lines when
disconnecting them to avoid introducing dirt and other
contaminants into the system.
Carefully follow the manufacturer’s recommendations
on reservoir and filter cleaning, and periodic changes
of hydraulic fluid.
Recommended Hydraulic Oil
Use Graco-approved Hydraulic Oil, Part No. 169236 (5
gal) or 207428 (1 gal)) or a premium, ISO grade 46
petroleum-based hydraulic oil containing rust and
oxidation inhibitors and anti-wear agents.
Before using any other type of oil in this motor, contact
your Graco distributor. Unauthorized use of lesser
grade oil or substitutes may void the warranty.
Hydraulic Oil Working Temperature
Models 217022 and 217338
The recommended hydraulic oil operating temperature
is 80 - 115° F (27 - 45° C). The motor seals will wear
faster and leakage may occur if the pump is operated
at higher oil temperatures.
If the hydraulic oil temperature approaches 130° F (54°
C), check the hydraulic fluid supply cooling system,
filters, etc. and clean or repair as needed.
Models 235435, 262818, and 24W139
The recommended hydraulic oil operating temperature
is 80 - 160° F (27 - 71° C). The motor seals will wear
faster and leakage may occur if the pump is operated
at higher oil temperatures.
If the hydraulic oil temperature approaches 180° F (82°
C), check the hydraulic fluid supply cooling system,
filters, etc. and clean or repair as needed.
Summary of Contents for 235345
Page 29: ...Notes 307158ZAP 29 Notes ...
