Cleanup
8
309584H
Cleanup
When you have finished spraying
1.
Shut off compressor. Disconnect air line from gun.
2.
Drain remaining material into a bucket until most of
the texture material is out of hopper.
3.
Fill hopper with clean water. Remove nozzle from
gun and allow water to flow through and out of gun.
4.
Flush until gun is clean.
5.
Remove hopper from gun and finish cleaning all
components. A soft brush may be used to help
loosen any dried on material from surface.
6.
Connect air line to gun. Turn on compressor. Open
gun air valve, forcing air through tip to clear out any
remaining material.
7.
Disconnect compressor.
To improve working condition for future use, after
cleaning, apply a few drops of light oil to:
•
air hose quick disconnect
•
material hose connections
•
flow adjustment on gun
Be sure to keep air passages in needle clean and
free of material.
Summary of Contents for 245924 A Series
Page 11: ...Notes 309584H 11 Notes...
