LL200 Compressor Installation
332230P
11
15. Use existing screws to install new fan grill with
opening (FF) onto belt. Do not over-tighten screws.
Make sure fan grill protrudes out; not into the
shroud.
16. Position compressor bracket (4) with three tabs
facing towards the fan grill. Center shaft coupler
both vertically and horizontally in slot. Insert four
screws (20) through the slots in the compressor
bracket and tighten to 23-27 ft-lb (31-37 N•m).
17. Place drop of medium strength thread locker on the
threads of each set screw. Using a 2.5 mm and a
4.0 mm Allen wrench, screw the set screws into the
shaft collar far enough so that the shaft collar can
slide on the compressor shaft. Rotate the shaft
collar so the pin faces up. Align the shaft collar pin
with the compressor shaft keyway as shown. Slide
the shaft collar onto the compressor shaft, pin first.