LL200 Compressor Installation
12
332230P
18. Slowly pull the starter rope to rotate shaft so that the
shaft keyway (5) faces up. Place the key (2) into the
shaft keyway. A light tap with a rubber mallet may
be needed to ensure the key seats completely.
19. Slide compressor onto the shaft coupler mounting
plate until the face of the compressor is flush with
compressor bracket. Rotate the compressor 90
degrees counter-clockwise until the set screw is
accessible.
NOTICE
Performing steps 19 through 23 out of order, or
incorrectly, may cause excessive side loading on the
compressor crankshaft and could cause a premature
failure of the compressor.