Operation
3A7467C
21
Adjust Abrasive Media
1. Perform the
2. Open the abrasive media ball valve (M). Trigger the
blast control switch (B).
3. Turn on the MediaTrak display (PK).
4. Slowly adjust the abrasive metering valve (T) to the
desired flow of abrasive media.
NOTE:
You may have to wait 1-2 minutes for the
abrasive material to reach the nozzle.
NOTE:
Use a piece of test material similar to what you
will be blasting. Always start as gently as possible and
then increase the blast force as necessary to clean
without doing any damage to the substrate.
Refill Pot with Media
As abrasive media leaves the pot during blasting, follow
the
NOTE:
If the pot loses pressure, follow the
WLD
M
8
8
0
0
0
0
0
ti36971a
B
PK
T
Summary of Contents for EcoQuip 2 EQ200t Elite
