Installation
3A8812B
7
Connect Electrical Components
on page 8 to make the
following electrical connections inside the electronics
control panel.
1. Connect the cable (1) to port 2 on the GCA FCM.
2. Connect the other wire ends to the proper
components.
3. Install the resistor (14) between terminal block 11
(C11) and terminal block 12 (C12).
NOTE:
Install the resistor on the bottom side of the
terminal blocks.
4. Connect the ERI optocoupler (A) and ERI pressure
switch (E) with jumper wires (8) and white ferrules
(9).
5. Connect the PTI pressure switch (D) to terminal
blocks C5 and C6 with jumper wires (8) with the
white ferrules (9).
6. Wire the EEO solenoid (F) to location J14 pins 5 and
6 on the circuit board with the orange ferrules (3).