Setup
4
3A5565B
Cleaning Tips/Clearing Clogs
NOTE:
Clean tip and tip guard at end of each work day.
1. Follow
Pressure Relief Procedure.
Engage trigger
lock.
2. Clean spray tip as follows:
a. RAC tips: Rotate tip 180° so
arrow on tip cylinder (20c)
faces backward. Disengage
trigger lock. Trigger gun into
pail or onto ground to remove
clog. Engage trigger lock. Rotate tip 180° back
to spray position.
b. Flat tips: Remove tip and clean with a
solvent-soaked brush.
3. RAC tips: If tip is still clogged:
a. Shut off sprayer and disconnect power source.
b. Open fluid drain valve (see
System
Requirements
on page 4) to relieve pressure.
c. Remove and clean spray tip.
20c
ti11483a
Adjust swivel position so spray fan
hits below roller cover.
1
Quickly trigger once and release to check pattern. Pattern
should be as wide as roller.
To narrow pattern, loosen roller handle and
move roller cover toward 180 degree
swivel. To widen pattern, loosen roller
handle and move roller cover away from
180 degree swivel.
ti23647a
2