7.1 Installing the Infant Restraint Without Base
Using Vehicle Belt
You must carefully follow the instructions provided by your
vehicle manufacturer, in addition to the information in this
manual. Before proceeding be sure you have read and
understood section 6, “Choosing an Appropriate Vehicle Seat
Location” on pages 26-32.
Make sure vehicle is on level ground
so that the level indicator, which is
attached to the infant restraint, can
be used to properly recline the infant
restraint.
If a front passenger seat is used (see
air bag warning, page 4), slide the
vehicle seat rearward as far as possible
from the dashboard. If a rear seat is
used, make sure the seat in front of it
is moved forward enough and is upright
enough to allow room for the infant
restraint.
1. Place the infant restraint without base in a rear-facing
position in a vehicle seat.
2. Thread the vehicle belt under both vehicle belt hooks:
33
Lap Belt
Lap/Shoulder
Belt
7.0 How to Install the Infant Restraint/Base
