Graco PJR REACTOR E-8p Setup Overview Download

Page: 6 / 6

Setup

Fill Wet-cups

Keep the felt washers in the pump wet-cups saturated

with ISO pump oil. The lubricant creates a barrier

between the ISO and the atmosphere.

Fill wet-cups through the slots in the plate, or remove a

screw and swing the plate to the side.

The pump rod and connecting rod move during

operation. Moving parts can cause serious injury such

as pinching or amputation. Keep hands and fingers

away from the wet-cup during operation. Shut off

power before filling the wet-cup.

. 4 Fill Wet Cup

Slots

TI17124a

Summary of Contents for PJR REACTOR E-8p

Page 1: ... European explosive atmosphere locations 2000 psi 14 MPa 138 bar Maximum Working Pressure See page 3 for a list of models Important Safety Instructions Read all warnings and instructions in this manual before using this equipment Save these instructions EN Setup Start Up Overview VEE AIR ONE SP Air Purge Gun 2 Part Adhesive Spray Applicator Portable Plural Component Sprayer ...

Page 2: ...ves E Control Panel F Electric Motor and Drive Housings G Hose Bundle H Spray Guns J Recirculation Outlet L Outlet Hose Connections M Power Cord P Fluid Inlet FIG 1 Component Identification JUST THE TIP THAT S ALL YOU NEED ADD JUST THE TIP TO YOUR V MANIFOLD TO ENABLE AIR PURGE SPLATTER FULL SPRAY AND STATIC BEAD SPRAY CAPABILITIES IN 1 GUN ...

Page 6: ...re Fill wet cups through the slots in the plate or remove a screw and swing the plate to the side The pump rod and connecting rod move during operation Moving parts can cause serious injury such as pinching or amputation Keep hands and fingers away from the wet cup during operation Shut off power before filling the wet cup FIG 4 Fill Wet Cup Slots TI17124a ...