40 308496
Service
Piston Repair (continued)
4.
Push on the piston rod (23g) to push the piston
assembly out the back of the gun.
5.
Inspect the o-rings (23a, 23b, 23c) and u-cup
packing (23f) for damage. See Fig. 33. Refer to
Fig. 34 to isolate air leakage problems.
6.
Lubricate the o-rings (23a, 23b, 23c) and u-cup
packing (23f) with petroleum jelly.
7.
Align the two stems (23d) with the holes in the gun
body and press the piston assembly into the back
of the gun until it bottoms.
8.
Installing the Actuator Arm and Nuts:
a.
Install the adjustment nut (36), actuator arm
(19), and jam nut (46) onto the piston rod
(23g). See Fig. 32.
NOTE: The jam nut (46) has a slightly larger hex and a
thinner profile than the adjustment nut (36).
b.
Thread the jam nut (46) flush with the end of
the piston rod (23g).Tighten the adjustment nut
(36) against the actuator arm (19). When
properly assembled, there should be about a
0.125 in. (3 mm) gap between the actuator
arm (19) and the fluid packing rod nut (U),
which allows the atomizing air to actuate
before the fluid actuates. See Fig. 32. In
addition, there should be 3 to 4 mm of elec-
trode needle travel when the gun is triggered.
If necessary, adjust the jam nut (46) position to
obtain these dimensions.
There should be a 0.125 in. (3 mm) gap between the actuator
arm (19) and the fluid packing rod nut (U).
Fig. 32
04823
U
46
36 23g
19
Apply a very light coat of lubricant to the o-rings (23a, 23b, 23c)
and u-cup (23f).
Align the two stems (23d) with the holes in the gun body and
press the piston assembly until it bottoms.
Fig. 33
03530
23g
23f
23e
23d
23c
23b
23a
Description
Function
O-Ring (23a)
Shaft Air Seal
It seals the cylinder air along the piston
rod. If the air leaks along the piston rod
(23g), replace this o-ring (23a).
O-Ring (23b)
Front Air Seal
It is the air shut-off seal. If the air leaks
from the air cap when the gun is detrig-
gered, replace these o-rings.
O-Ring (23c)
Back Air Seal
It separates the cylinder air pressure from
the fan and atomizing air pressure.
U-cup (23f)
Cylinder Air
Seal
If the air leaks from the small vent hole in
the back of the manifold when the gun is
triggered, replace the u-cup.
Fig. 34
Fan Air Side
Atomization Air Side
23a
23c
23b
23f
03531
Summary of Contents for PRO 5500wb
Page 49: ...308496 49 Notes ...
Page 59: ...308496 59 Notes ...