Cleanup and Storage
3A7649A
21
b.
Reverse the Spray Tip to UNCLOG
position, pull the Sprayer Trigger
for 30 to 60 seconds until sprayer
is clean. Release the Sprayer
Trigger.
13. Do not store sprayer with water in pump.
To remove all water prior to storage:
a.
Remove cup assembly from
sprayer.
b.
Turn Prime Pump/Spray Knob
downward to PRIME position.
c.
Pull Sprayer Trigger for 5 seconds
d.
Disconnect power (unplug Power
Cord).
14. Remove cup assembly from sprayer.
Separate Cup Lid from Cup Support and
pour unused water into waste bucket.
15. Dispose of the fluid in the waste bucket
according to the instructions on the
disinfectant container label and
applicable regulations.
16. Remove Spray Tip, Spray Tip Guard,
and Pump Filter from sprayer. Clean with
warm water. A soft brush can be used if
needed.
17. Use a soft cloth to clean the Cup Support
and Cup Lid.
18. Wipe disinfectant off the outside of the
sprayer using a soft cloth moistened with
water.
NOTICE
Do not run sprayer without fluid. Running
sprayer dry will cause damage to the
pump.
NOTICE
Do NOT submerge the sprayer. Do NOT
splash, immerse, or spray down the battery
or charger. Do NOT clean the battery with
anything other than a soft cloth moistened
with water. Doing these will cause damage
to the sprayer.
ti23372a