3 Rear
Facing
36
3-D Install Without Base
Rear-Facing
With
Vehicle Seat Belt
1. Place Car Seat in
Back Seat of the
Vehicle
Place the car seat
on the vehicle seat.
Push it back until the
front of the car seat
touches the vehicle
seat back.
Check the rear-facing
level line. The red
level line on the side
of the seat MUST
BE LEVEL with the
ground.
If needed, rolled
towels may be placed
under the base, at the
vehicle seat crease,
until the level line is
level with the ground.
3 Rear
Facing
37
2. Route the Vehicle
Seat
Belt
Thread vehicle seat
belt through the
rear-facing belt path
(marked with a blue
label) and buckle it.
The seat belt should
not be twisted.
3. Lock the Vehicle
Seat
Belt
In most vehicles
today, slowly pull
the shoulder belt all
the way out and then
let it go back in. You
will hear a “clicking”
sound. Slowly pull
out on the belt and it
should be locked. If
not, review your car’s
owner manual and
section 6-D.
