Graco T-Max Applicator 17Z054, Operation - Repair - Parts

Setup 

6

312879E

Setup

Make sure sprayer is turned OFF and unplugged from power
source. Refer to your sprayer instruction manual for priming
and spray instructions.

Airless Spray Setup

Connect Applicator to Sprayer

1. Attach supply hose to sprayer fluid outlet.

2. Attach other end of supply hose to applicator swivel 

(17).

3. Refer to sprayer instruction manual for priming 

instructions.

Install Applicator Tip and Guard

1. If equipment has recently been operated, perform 

Pressure Relief Procedure

, page 4.

2. Using a pencil or similar object, insert seal (20) into 

back of guard (18).

3. Install guard (18) onto end of applicator (9).

4. Insert tip (19) in guard (18). Tighten retaining nut.

Air Spray Setup

Connect Applicator to Sprayer

1. Attach supply hose to sprayer fluid outlet.

2. Attach other end of supply hose to applicator swivel 

(17).

3. Install air hose to applicator check valve (8).

4. Refer to sprayer instruction manual for priming 

instructions.

Install Applicator Air Nozzle

1. If equipment has recently been operated, perform 

Pressure Relief Procedure

, page 4.

2. Install air nozzle (27; 37d-37g) and retainer (10). 

3. Replace retainer with Fine Finish Kit (40) for finer 

finishes.

To avoid serious injury from skin injection, do not put 
your hand in front of the spray tip when installing or 
removing the spray tip and tip guard.