Setup/Startup
18
3A8108A
Handlebar Adjustment
The handlebar is adjustable, allowing users
to customize the height and tilt for
comfortable performance. To adjust
handlebar, follow the steps below:
1.
To adjust the tilt, use a 3/4 in. wrench to
loosen the four bolts (two on each side)
holding the handlebars to the display
unit.
2.
Tilt handlebars until they are in the
desired location.
3.
Re-tighten bolts.
1.
To adjust the height of handlebars use a
3/4 in. wrench to loosen the four bolts
(two on each side) holding the
handlebars to the frame of the unit.
2.
Slide handlebars and up or down to set
the desired height.
3.
Re-tighten bolts.
Summary of Contents for TapeLazer HP Automatic
