Maintenance
40
3A8108A
Maintenance
Periodic Maintenance
DAILY:
Check engine and compressor oil
level and fill as necessary.
DAILY:
Check hoses for wear and damage.
DAILY:
Check pressure drain valve for
proper operation.
DAILY:
Check and fill gas tank.
DAILY:
Verify calibration.
AFTER THE FIRST 20 HOURS OF OPER-
ATION:
Drain engine oil and refill with clean
oil. Reference Honda Engines Owner’s
Manual for correct oil viscosity.
WEEKLY:
Remove engine air filter cover
and clean element. Replace element, if nec-
essary. If operating in an unusually dusty
environment: check filter daily and replace,
if necessary.
Replacement elements can be purchased
from your local HONDA dealer.
AFTER EACH 100 HOURS OF OPERA-
TION:
Change engine oil. Reference Honda
Engines Owner’s Manual for correct oil vis-
cosity.
SPARK PLUG:
Use only BPR6ES (NGK) or
W20EPR-U (NIPPONDENSO) plug. Gap
plug to 0.028 to 0.031 in. (0.7 to 0.8 mm).
Use spark plug wrench when installing and
removing plug
.
Air Compressor
Before operation, ensure oil is visible on
threads of fill port. If not full, fill with oil until
visible on threads.
To check oil level:
1.
If unit is equipped with drain plug,
remove drain plug and verify oil is visible
on threads of drain port. If not full, fill with
oil through drain port until visible on
threads.
2.
If unit is equipped with sight glass, verify
oil level is above red dot. If not, remove
oil breather and fill with oil through
breather port until level is above red dot.
NOTE:
Oil level will change at slower rate
than poured as it makes its way into the
crankcase. Pour small amounts at a time,
checking between pours.
Routine maintenance is important to ensure
proper operation of your compressor.
Maintenance includes performing routine
actions to keep your compressor in operation
and prevent trouble in the future.
*Drain oil by siphoning from drain port. Use
approximately 4 fl. oz. of SAE 30W air
compressor oil. If equipped with a drain plug,
proper oil level is attained when oil is visible
on threads of drain port. If equipped with a
sight glass, proper oil level is attained when
oil is above red dot.
NOTICE
Failure to properly fill compressor with oil
can result in severe or catastrophic
damage to the compressor.
Activity
Interval
Replace air filter
Every 200 hours, or as needed.
Change oil*
After first 50 hours, then every
200 hours or every three
months.
Summary of Contents for TapeLazer HP Automatic
