Operation
3A8108A
29
System Delay Example - Auto Mode/Skip Line
[A] Auto Mode
Skip Line placement using SD
example shown: 1 ft line, 2 ft space, 72 inch System
Delay.
Tape Application Button Activity
Press and RELEASE tape application button when
pointer [A] reaches start point [B]. Press and
RELEASE tape application button a second time
after pointer [A] passes ending line [D]. Use this
option when the spacing between lines remains
consistent.
If the button is pressed before the end of the
programmed length [C], that line will end at that
point, except:
if the pointer is less than 1 foot from the start of the
line [B], the button press will be ignored, with a
message on the screen. The operator will need to
travel further before pressing the button to end the
line.
After pressing the button a second time (either after
[D] or before [C]), the operator can press the button
again to start another set of skips. However, if the
press occurs less than 1’ from the previous press,
the press will be ignored, with a message on the
screen. The operator will need to travel further
before pressing the button to start the next skip.
Tape Interrupt
All system delay operation can be canceled by:
turning System Delay OFF, turning the LINE TYPE
button off (both LEDs off), or double pressing the
tape application button.
Summary of Contents for TapeLazer HP Automatic
