Troubleshooting
34
3A4476E
Spray pattern is too wide:
Sprayer is too far away
from target surface.
Move sprayer closer to surface.
Incorrect spray tip for
application of material.
Install different size spray tip.
Spray pattern “spits” at the
beginning or end of pattern:
Excess material has
accumulated on spray tip
guard assembly or spray
tip is partially clogged.
Clean spray tip guard. See
Spray tip not inserted
completely into spray tip
guard.
Spray tip is worn.
Replace spray tip. See
Sprayer is dirty
Flush sprayer.
Front valve has reached
the end of its life.
Replace front valve assembly.
Spray tip continues to drip or ooze
material after trigger is released:
Spray tip is worn.
Replace spray tip. See
Spray tip not inserted
completely into spray tip
guard.
Material leaks around spray tip
guard or spray tip handle
Spray tip seal and seat are
damaged or not properly
installed.
Problem
Cause
Solution
ti30016a
Summary of Contents for TC Pro
Page 36: ...Notes 36 3A4476E Notes ...
Page 37: ...Notes 3A4476E 37 Notes ...