Start Up
10
3A4476E
1.
Install FlexLiner in the cup support.
2.
Fill FlexLiner with material. Securely
tighten cup cover onto cup support. For
proper sprayer operation lid must seal
tightly with the cup.
3.
Align VacuValve on cup cover with Prime
Pump/Spray knob. Push cup assembly
onto sprayer and twist to lock.
4.
The VacuValve is an important part of
your new sprayer. It is used to evacuate
the air out of the FlexLiner. Your sprayer
will not spray if there is air in the
FlexLiner.
5.
Open VacuValve cap. Tilt the sprayer so
the VacuValve is the highest point,
causing any air in the FlexLiner to rise to
the VacuValve. Gently squeeze the
FlexLiner to evacuate all air through the
VacuValve air hole. Once you see
material enter the VacuValve reservoir,
all air should be evacuated from the
FlexLiner.
6.
Stop squeezing the FlexLiner and snap
the VacuValve cap closed. You will hear
the cap click when it is closed properly.
ti23361a
ti29719a
ti30037a
ti29721a
ti29723a
Summary of Contents for TC Pro
Page 36: ...Notes 36 3A4476E Notes ...
Page 37: ...Notes 3A4476E 37 Notes ...