Cleanup
3A4476E
19
11. Turn Prime Pump/Spray knob forward to
SPRAY position.
12. While holding the sprayer upside down
point the sprayer into a waste pail.
a.
With the spray tip in the SPRAY
position, pull the trigger for five
seconds. Release the trigger.
b.
Reverse the spray tip to UNCLOG
position, pull the trigger for five
seconds. Release the trigger.
13. If second spray tip was used, remove
cleaned spray tip from spray tip guard
and install second spray tip. See
, page 22. Repeat steps
11 and 12 to clean second spray tip.
14. Remove cup assembly and discard used
fluid. Dispose of used cleaning fluid
properly.
15. Replace cleaning fluid and repeat steps
6 – 14 until spray output is clean.
IMPORTANT!
For best results, do not spray
more than one cup of water through the tip
while cleaning. If more flushing is needed,
remove the tip from the sprayer to avoid
excessive wear.
ti29768a
Summary of Contents for TC Pro
Page 36: ...Notes 36 3A4476E Notes ...
Page 37: ...Notes 3A4476E 37 Notes ...