j.
Dispense into grounded metal waste
container until hopper is almost empty then
close air motor pilot ball valve (G).
k.
Repeat this entire “Circulate clean water
or solvent” step one more time to ensure
system is thoroughly flushed.
12. After performing the previous step at least twice,
drain remaining flushing fluid from system:
a.
Place grounded metal drain pan beneath
pump lower inlet fittings.
b.
Remove hopper and fittings between hopper
and pump lower.
c.
Use a screwdriver to lift the pump lower inlet
ball. This will drain the remaining material
from the pump lower. When the pump stops
draining, release the pump lower inlet ball.
d.
Install fittings and hopper.
e.
Install camlock retaining straps.
f.
Starting at the pump, raise the hose bundle
above your head and slowly move towards
the applicator. As you move towards the
applicator, the remaining fluid in the hose will
drain from the applicator into the bucket.
13. Disassemble and clean the pump at the end
of every day. The procedure takes about 10
minutes. See
Disassemble and Clean the Pump
.
332612C
29
