Before You Start
4
3A2852B
10. Place reservoir into backpack.
NOTE:
The air com-
pressor always needs to be on while the sprayer is
in operation (if the light is on, the air compressor is
on). If fluid level is at half or less, allow up to 2 min-
utes for reservoir to pressurize before initial use.
11. Pull strap until reservoir is firmly secured into back-
pack.
12. Close prime valve on sprayer.
13. Place backpack system on operator.
You are now
ready to spray!
NOTE:
If the tip needs to be changed while spraying, be
sure to follow
Pressure Relief Procedure
(see sprayer
manual). Turn air compressor off and slowly remove
from lid assembly. This will ensure pressure is released
from reservoir before changing the tip.
System is now pressurized.
Failure to properly
depressurize system will result in material discharging
from hose and possible injury.
Always turn off and slowly remove air compressor from
lid assembly to depressurize system before removing:
•
Hose set from sprayer
•
Hose set from lid
•
Lid from reservoir
ti16507a
ti16521a
ti15425a
CAUTION
ti16510a
All written and visual data contained in this document reflects the latest product information available at the time of publication.
Graco reserves the right to make changes at any time without notice.
For patent information, see www.graco.com/patents.
Original instructions.
This manual contains English. MM 3A2852
Graco Headquarters:
Minneapolis
International Offices:
Belgium, China, Japan, Korea
GRACO INC. AND SUBSIDIARIES • P.O. BOX 1441 • MINNEAPOLIS MN 55440-1441 • USA
Copyright 2012, Graco Inc. All Graco manufacturing locations are registered to ISO 9001.
www.graco.com
Revision B- January 2013
