Operation
40
313873J
100:XX Ratio Output Feature
The user now has the capability to enter, edit and dis-
play ratios in 100 to XX format, rather than the standard
XX to 1 format. For instance, when operating in the
default XX:1 format, a typical run screen may appear
like the following:
To configure the system into 100:xx format, the option is
available on the Advanced #4 setup screen by selecting
the “Display Ratio in 100 to xx” option, as indicated
below:
After the above selection, the same run screen will
appear like the following:
As indicated above, both the ratio set point (bottom
right), and actual ratio dispensed (top middle) are output
in the 100:xx format.
100:XX Ratio Set point Entry
When altering the ratio set point for a dispense, the
same control numeric entries apply. The following illus-
trations apply when altering the ratio set point for an
operator mode dispense, the shot recipes, and a flow
meter calibration dispense.