Grad-M 90040121, User Manual

13

ner intended for the particular type of power tool, taking 
into account the working conditions and the work to be 
performed. Use of the power tool for operations different 
from intended could result in hazardous situation.

5) Service

a. Have your power tool serviced by a quali

fi

 ed repair 

person using only identical replacement parts. This will 
insure that the safety of the power tool is maintained.

SAFETY RULES FOR DRILLS

•  Wear ear protectors with hammer drills (exposure to 

noise can cause hearing loss)

•  Use auxiliary handles supplied with the tool (loss of 

control can cause personal injury)

•  Avoid damage that can be caused by screws, nails 

and other elements in your workpiece; remove them 
before you start working

•  Always keep the cord away from moving parts of the 

tool

•  When you put away the tool, switch off the motor and 

ensure that all moving parts have come to a com-
plete standstill

•  Use completely unrolled and safe extension cords 

with a capacity of 16 Amps (UK 13 Amps)

•  In case of electrical or mechanical malfunction, im-

mediately switch off the tool and disconnect the plug

•  Flawless functioning of the tool can be guaranteed 

only when original accessories are used

•  Use only accessories with an allowable speed 

matching at least the highest no-load speed of the 
tool

•  This tool should not be used by people under the age 

of 16 years

•  Be careful not to drill or drive into areas where elec-

trical wires may be contacted

•  If the cord is damaged or cut through while working, 

do not touch the cord, but immediately disconnect 
the plug

•  Never use tool when cord is damaged; have it re-

placed by a quali

fi

 ed person

•  Always check that the supply voltage is the same as 

the voltage indicated on the nameplate of the tool 
(tools with a rating of 230V or 240V can also be con-
nected to a 220V supply)

•  If the drill bit becomes unexpectedly jammed (caus-

ing a sudden, dangerous reaction), immediately 
switch off the tool

•  Be aware of the forces that occur as a result of jam-

ming (especially when drilling metals); always hold 
the tool 

fi

 rmly with both hands and take a secure 

stance

•  Always disconnect plug from power source before 

making any adjustment or changing any accessory

•  Holding the tool 

- keep the ventilation slots uncovered
-  do not apply too much pressure on the tool; let the 

tool do the work for you

Your machine is double insulated in accord-
ance with  EN 50144; therefore no earthwire 
is required.

MAINTENANCE

Make sure that the machine is not live when car-
rying out maintenance work on the motor. 

Regularly clean the machine housing with a soft cloth, 
preferably after each use. Keep the ventilation slots free 
from dust and dirt.If the dirt does not come off use a soft 
cloth moistened with soapy water. Never use solvents 
such as petrol, alcohol, ammonia water, etc. These sol-
vents may damage the plastic parts.
The machine requires no additional lubrication.
Should a fault occur, e.g. after wear of a part, please 
contact your local dealer.

ENVIRONMENT

In order to prevent the machine from damage during 
transport, it is delivered in a sturdy packaging. Most of 
the packaging materials can be recycled. Take these 
materials to the appropriate recycling locations. Take 
your unwanted machines to your local dealer. Here they 
will be disposed of in an environmentally safe way.