Approved Attachments
Although the carriage/fork combination is most frequently used, several other
GRADALL-approved attachments are available for use with your material handler.
Contact your GRADALL Material Handler Distributor or Gradall for information
on approved attachments designed to solve special material handling problems.
The serial number plate lists attachments approved for use with your handler.
However, there may be additional approved attachments available. Contact
your GRADALL Material Handler Distributor for further information.
Non-Approved Attachments
Do not use non-approved attachments for the following reasons:
• GRADALL cannot establish range and capacity limitations for “will fit”,
homemade, altered, or other non-approved attachments.
• An overextended or overloaded handler can tip over with little or no warning
and cause serious injury or death to the operator and/or those working near
the handler.
• GRADALL cannot assure the ability of a non-approved attachment to perform
its intended function safely.
• Non-approved attachments may cause structural or other damage to the
handler. Such damage could cause dangerous operating conditions resulting
in serious injury or death.
Carriage/Fork Capacities
The standard carriage/fork capacity chart (located on the dashboard) indicates
maximum reach and load capacities for handlers equipped with an approved
carriage/fork combination.
These limitations apply to standard, GRADALL-
approved carriage/fork combinations, except as stated on the capacity
chart.
Non-standard carriage/fork combinations (greater or lesser capacity) may be
furnished by GRADALL at customer’s request or may be available for installation
because they were furnished for a different application.
If a carriage/fork combination of lesser capacity is used,
the overall machine
capacity is reduced
to carriage/fork capacity as indicated on carriage/fork
serial number plate.
If a carriage/fork combination of greater capacity is used, the overall machine
capacity may be reduced because of additional attachment weight and/or other
considerations.
Contact your local GRADALL Distributor to determine
capacity limitations.
Other Attachment Capacities
A serial number/capacity plate is attached to all GRADALL-furnished attachments.
Do not assume that any GRADALL attachment may be used on any
GRADALL Material Handler.
First, check the listing of approved attachments on handler serial number plate.
If the attachment in question is not included in the list, contact your local
GRADALL Distributor to check whether or not the attachment is approved.
Next,
if the attachment is approved for use
with your handler, compare
maximum capacity from attachment serial number plate and value stamped on
forks to maximum capacity for that
attachment
as indicated on material handler
serial number plate.
The smallest of these values is correct for your
handler.
ATTACHMENTS
14.0
Attachments which have not been
approved for use with your handler
could cause machine damage or
an accident resulting in injury or
death.
Never use an attachment without
the appropriate, GRADALL
supplied capacity chart for that
particular attachment installed in
the handler.
The capacity of forklift, attachment
and fork combination may be less
than the capacity shown on
attachment. Consult forklift
nameplate and also ensure forks
are of proper size.
Forks rated less than the
attachment capacity decrease
capacity of attachment to that of
forks. Forks rated more than
attachment capacity do not
increase attachment capacity.
CAUTION
!
WARNING
!
WARNING
!
