Section 2 - Pre-Operation and Controls
2-1
80804002
SECTION 2 - PRE-OPERATION AND CONTROLS
2.1
PRE-OPERATION CHECKS & INSPECTION
Note:
Complete all required maintenance before operating unit.
FALL HAZARD.
Use extreme caution when checking
items beyond your normal reach. Use an approved
ladder. Failure to comply could result in death or
serious injury.
Walk around inspection must be performed at beginning of each work shift or at
each change of operator.
Ensure all Safety decals are legible and in place. Clean or replace as required. Refer
to pages 2-5 through 2-7.
Before removing filler caps or fill plugs, wipe all dirt and grease away from the ports.
If dirt enters these ports, it can severely reduce component life.
When adding fluids, refer to
on page 7-1 to determine
proper fluid type, and
“Service & Maintenance Schedules”
on page 5-3 for intervals.
WARNING
OW0021
Summary of Contents for XL3100IV
