Section 2 - Pre-Operation and Controls
2-25
80804002
Information Display Area
Note:
When ignition is turned to the “RUN” position (see page 2-27 for details), the
engine stop, check engine, and optional engine preheat displays illuminate for
approximately two seconds and then go off. At lower temperatures, the optional
engine preheat light may continue to illuminate until the intake manifold warms to
proper temperature.
1.
Engine Stop Indicator: Illuminates red and a pulsing alarm is activated to
indicate excessive engine temperature or low engine oil pressure. Stop engine
immediately and repair before continued use.
2.
Check Engine Indicator: Illuminates yellow to indicate an engine malfunction.
Stop engine and repair before continued use.
3.
Engine Preheat Indicator (if equipped): Illuminates yellow to indicate grid
heaters are warming intake manifold to proper starting temperature.
4.
Undercarriage Key Indicator: Illuminates green to indicate undercarriage
ignition key is in the “RUN” position (see page 2-27 for details).
5.
Upperstructure Key Indicator: Illuminates green to indicate upperstructure
ignition key is in the “RUN” position (see page 2-44 for details).
6.
Air Conditioning Indicator (if equipped): Illuminates green to indicate air
conditioner is activated.
7.
Interaxle Differential Indicator (XL4100IV & XL5100IV only): Illuminates green
to indicate interaxle differential lock is engaged.
8.
Torque Limiter Indicator: Illuminates yellow and an alarm is activated to indicate
Diesel Exhaust Fluid (DEF) level is low enough to begin engine torque deration.
If light is solid, engine torque is greater than 50%. If light is blinking, engine
torque is less than 50%.
9.
Front Axle Drive Indicator (if equipped): Illuminates green if front axle drive is
activated.
STOP
M
OAC1650
AXLE
DIFF
CHASSIS
KEY
UPPER
KEY
FRONT
AXLE
DRIVE
INTER
AXLE
DIFF
13
14
12
11
9
7
6
5
4
3
2
1
8
10
Summary of Contents for XL3100IV
