Owner’s Manual
SS-WM15-TAB
1. Use the wall plate to mark the position of the mounting
holes on the wall.
2. Drill holes in the marked locations. Make appropriately
sized holes for the wall anchors, molly bolts, or toggle
bolts. If you’re using wall anchors, tap the anchors into
the holes.
Note:
Many wall anchors and molly bolts are self-
tapping and don’t require a drill for installation.
3. Put the plate against
the wall, and insert
screws (for wall
anchors), molly
bolts, or toggle bolts
through the holes,
and fasten them until
they’re fully tightened,
and the wall bracket
is secure.
Note:
When screwing
the plate directly
into a wall stud,
make sure at least
two screws are
attached to the stud.
Mounting Instructions
