10
Attaching the Security Clamps to a
Concrete Wall or Concrete Blocks
It’s important to use the security cable system for additional protection
against tipping over caused by accidental bumping or moving of the
easel and your display.
1.6 in.
9/32 in.
U
4X
S
2X
V
4X
Caution!
Make sure the concrete wall or block is solid and at least 8 inches (20 cm)
thick. Install the security clamps at least 16 inches apart. If the concrete exhibits
cracks or other defects, this may result in failure of the wall anchors and cause
serious personal injury or damage your display.
Warning!
Do not drill into the mortar
between concrete blocks.
1.
Use a pencil to mark drilling
holes for the four anchor screws.
2.
Use a 9/32-inch (7 mm) concrete
drill bit to predrill the marked
spots 1.6 inches (40 mm) deep,
and then clean out the debris
from the holes.
3.
Use a hammer to tap the
wall anchors into the
predrilled holes.
4.
Use the four anchor screws
to attach the security
clamps to the wall. Use the
Philips screwdriver to further
tighten the screws, but do
not overtighten.
