8-11
Chapter 8: Canyon 456
Livewells
To operate the livewell, turn the switches on at the CZone control panel� The switches are
designated port and starboard and operate independently� There are two 1500 GPH pumps in the
seachest that provide water to each of the livewells� Water will enter through a plenum along the
side of the livewell and be distributed through a series of holes arranged vertically along the
plenum� The water will rise and eventually it will reach the overflow fitting and drain overboard
when the plug is inserted into the bottom drain� Replacement of livewell pumps requires the
removal of the Seachest lid� See page 6-5 for instructions on lid removal�
Raw Water Washdown
The Canyon 456 is equipped with a Glendinning electric hose reel with a 35' washdown hose�
This hose reel is located in the lean bar on the starboard side� To use the washdown, first turn on the
raw water washdown pump on the CZone panel� The pump will use water from the Seachest to
pressurize the system� To deploy the hose, pull the spray nozzle out of the box and pull the
appropriate amount of hose out� To retract the hose, push the switch directly above the washdown
box� Continue depressing this switch until the spray nozzle is completely in the box� There are limit
switches in the back of the box that stop the reel when the hose and nozzle are fully retracted�
Seakeeper
The 456 is equipped with a Seakeeper gyro stabilizer� The Seakeeper reduces up to 95% of the
roll in the boat� It contains a gyroscope that is actuated to counteract the forces of the waves
experienced by the boat� The Seakeeper is controlled by a panel at the helm� To activate the
Seakeeper, turn on the accessory in CZone to supply power to the panel� To supply power to the
unit, press the power button on the Seakeeper panel� The unit needs to spool up for at least 35
minutes to reach operating RPMs� To lock the boat in a stable position, press the image of the three
ships� This activates the Seakeeper’s anti-roll capabilities� Refer to your Seakeeper Owner’s Guide
for detailed operation instructions�
Note:
If possible, turn on the Seakeeper with shore power while at the dock before departing to
minimize spool up time underway�
Summary of Contents for Canyon 456
