8-23
Chapter 8: Canyon 456
USB Charging Outlets
Your boat is equipped with four USB charging outlets� One is located in the port bow, one at the
helm, and two inside the cabin� These outlets provide easily accessible power supplies for charging
accessories such as cell phones and tablets�
Vacuflush
®
Head System
The VacuFlush
®
head system consists of a vitreous china bowl, a vacuum pump with tank,
holding tank, and two control panels� To operate the head, the head and freshwater switches on the
CZone panel must be in the “on” position� This provides power to the vacuum pump, and pressurizes
the freshwater system� Since this unit uses freshwater, it is not necessary to open a seacock prior to
use� Instructions on the operation of your VacuFlush
®
head are as follows:
1� Verify that the switches on the CZone panel are in the “on” position�
2� To add water prior to flushing, push the "Add Water" button on the Vacuflush
®
control
panel until the desired level is reached�
3� To flush, hold the flush button on the Vacuflush
®
control panel until contents clear the
bowl�
N OT I C E
Do not dispose of sanitary napkins or other non-dissolving items in the toilet. Also, do not
attempt to flush facial tissue, paper towels, or large quantities of toilet paper.
Located on the aft wall of the vanity is a level monitor and discharge control panel which
displays the fill level of the holding tank� When the tank is full, it can be discharged overboard or
emptied through the deck pump-out fitting� Following are instructions on both operations:
Deck Pump-out
1� Remove the cap from the deck pump-out fitting located on the starboard gunnel�
2� Connect a vacuum hose from a pump-out station to the deck fitting and run until the tank
is empty�
3� Replace the cap on the deck pump-out fitting�
Overboard Discharge
1� Press the “open” side of the discharge seacock switch on the cabin switch panel� This will
open the Holding Tank Discharge Seacock and the switch will illuminate green when fully
open� If you need to operate the valve manually, the valve is located in the head rigging
compartment on the outboard side of the head� An access panel is provided in the wall
next to the toilet�
Note:
Wait at least 5-10 seconds before discharging overboard to allow the seacock to fully
open�
2� Place the “Head” and “Hold Tank Discharge” switches on the CZone panel in the “on”
position�
Summary of Contents for Canyon 456
