8-20
Chapter 8: Canyon 456
Connecting The Shore Power
1� Verify that the external power is a 4-wire grounded system with amperage and voltage
ratings compatible with the boat’s AC system ratings (50A, 125/250V)�
2� Be sure there is sufficient cable length to allow for normal movement between the boat
and the dock� The Canyon 456 is equipped with a 35ft retractable shore power cable�
3� Turn the breaker at the dock outlet to the off position�
4� Connect the shore power cable to the dock outlet and turn the dock outlet breaker to the
“on” position�
5� Ensure the ELCI breaker is in the “on” position�
Note:
The ELCI should be tested monthly by cycling the switch on the box on the port side
of the aft rigging area�
6� Select “Shore Power” on the AC Mains tab on the CZone panel to start the flow of
electricity to the boat�
W A R N I N G
If the reverse polarity indicator on the CZone panel is activated, immediately disconnect the
shore power cable and have a qualified electrician correct the fault.
Disconnecting The Shore Power
1� Turn all CZone switches off before disconnecting shore power�
2� Turn the breaker at the dock outlet to the off position�
3� Disconnect the shore power cable at the dock outlet�
4� Retract the shore power cord using the switch on the aft cockpit wall on the engine flush
panel� Feed the cord into the deck keeping it straight and under slight tension to avoid
bending the reel�
N OT I C E
Keep inlet cover closed tightly when not in use.
Summary of Contents for Canyon 456
