E
X P R E S S
3 7 0
8–2
O p e r a t i o n O f St a n d a r d F e a t u r e s
A
CCESSORY
S
WITCH
P
ANELS
At the helm you will find an accessory switch panel. An additional switch panel is located
above the port bait station in the cockpit. The livewell, raw water washdown, and spreader lights
switches make up this cockpit switch panel. Refer to the
“370 DC Accessory Wiring Color - Fuse/
for overcurrent protection amperage ratings for each circuit. Also see
“12V DC Accessory Switch Panel Diagram” on page 8–48
for switch panel wiring diagrams. Consult your dealer for specific
information or questions on the accessories included on your boat.
• Aft and Forward Bilge
These two-way switches serve as manual switches for each bilge pump. These switches
operate independently of each other. Two circuit breakers located above each switch provide
over-current protection at the panel for each bilge pump circuit.
• Cockpit Light
The cockpit lights (blue) provide illumination in the cockpit and helm areas. This switch also
activates the lighted cup holders. A circuit breaker located above this switch provides over-
current protection for this circuit.
• Electronics Box
This momentary switch activates the lift which opens and closes the raisable electronics box
at the helm. A circuit breaker located above this switch provides over-current protection for
this circuit.
• Hardtop Lights (optional)
This momentary switch activates the multi-colored recessed downlights. Depressing the
switch one time turns the lights on. Subsequent pressing of the switch will cycle the lights
through the colors. Press and hold for 3 seconds to turn lights off.
Note: Depressing/cycling the switch too quickly may cause the light colors to be
unsynchronized. To reset the light colors, turn the lights off by pressing and holding for 3
seconds.
• Horn
This momentary switch activates a horn which meets the requirements of the USCG for
sounding devices. A circuit breaker located above this switch provides over-current protection
for this circuit.
• Livewell
This switch, located on the cockpit switch panel, activates the livewell pump and light. A
circuit breaker located beside this switch provides over-current protection for this circuit.
• Navigational/Anchor Lights
This three-position switch (NAV-OFF-ANC) changes the lighting configurations to running or
anchor lights. A circuit breaker located above this switch provides over-current protection for
this circuit.
• Raw Water
This switch, located on the cockpit switch panel, activates the raw water washdown system. A
circuit breaker located beside this switch provides over-current protection for this circuit.
Summary of Contents for Express 370
