E
X P R E S S
3 7 0
8–13
C
OCKPIT
S
HOWER
To operate the cockpit showers located in the starboard rigging station and beside the aft
fishbox near the transom door, the freshwater switch located on the AC/DC panel must be in the
“on” position or a shore water supply must be connected. To operate the shower at the rigging
station, pull out the hose and depress the lever on the back of the wand to spray water. For
continuous or hands free operation, pull up on the lever until it reaches the locked position. The
aft cockpit shower may be used by simply removing the shower wand from the storage cup and
depressing the button on the shower head. To reinstall either shower wand, gently feed the hose
down through the deck and return the faucet to the base. To supply the hot water to the cockpit
showers, make sure the hot water heater is on
(reference “Water Heater” on page 8–23)
, then
adjust the mixer knob located at the cockpit showers.
C
OCKPIT
S
WITCH
P
ANEL
This panel is located above the starboard rigging station. It is used to operate those systems
which are not included on the AC/DC panel or the accessory switch panel. The switches are
backlit for low light situations and have individual breakers located above them. Refer to
“Accessory Switch Panels” on page 8–2
for information regarding the operation of switches
included on this panel.
C
OMPASS
The compass is located at the helm station in direct view of the operator when navigating the
boat. Following the compass instructions included in the “Owners Packet” will help you make
compensation adjustments.
F
RESHWATER
S
YSTEM
The Express 370 comes with a pressurized freshwater system. The freshwater pump is
activated by the freshwater switch on the AC/DC panel and supplies water from the 54 gallon
(204.4 L) water tank to the freshwater components on board. The freshwater pump and
accumulator tank can be accessed through the panel in the port wall of the aft berth compartment.
The water tank is located aft, next to the transom. This freshwater pump is by-passed when
connected to a shore water supply; therefore, the freshwater switch should not be on when
connected to shore water. See
“Pressurized Freshwater System Layout” on page 8–31
diagram.
F
RESHWATER
W
ASHDOWN
To operate the freshwater washdown, turn on the freshwater switch on the AC/DC switch
panel. This system will now be pressurized at the “freshwater” washdown outlet. A hose with a
spray nozzle attached may be used intermittently without turning the switch off in the same
fashion as a home garden hose with a nozzle. The freshwater pump has an internal pressurization
switch that will maintain water pressure as needed until the switch is turned off at the switch
panel.
Summary of Contents for Express 370
