2 8 3 R
E L E A S E
8–9
H e a d O p e r a t i n g I n s t r u c t i o n s
M
ARINE
H
EAD
(W/ H
AND
P
UMP
) O
PERATION
1. Open the marine head inlet seacock. This seacock is in the forward bilge and is labeled
“Head Inlet”. It can be accessed through the upper flip down door located on the aft head
wall.
2. Position the wet/dry bowl selector in the wet bowl setting. Fill the toilet with water by
pumping the handle several times.
3.
Flush
the toilet by pumping the handle several more times in the wet bowl position.
4. Move the bowl selector to the dry bowl position and pump the handle until almost all of the
water is removed. Leave the toilet in the dry bowl position when not in use.
E
LECTRIC
M
ARINE
H
EAD
O
PERATION
1. Open the marine head inlet seacock. This seacock is in the forward bilge and is labeled
“Head Inlet”. It can be accessed through the upper flip down door located on the aft head
wall.
2.
Flush
the toilet by turning the flush control knob clockwise on the pump beside the bowl.
Turn the flush control knob counter clockwise to remove most of the water from the bowl.
E
MPTYING
M
ARINE
H
EAD
H
OLDING
T
ANK
B
Y
O
VERBOARD
D
ISCHARGE
1). Open the marine head discharge seacock. This seacock is in the forward bilge and is labeled
“Head Disc”. It can be accessed through the upper flip down door located on the aft head
wall.
2). Press the show level button on the tank level monitor.
3). Press the pump out button until the light on the monitor indicates the tank is empty.
4). Close the discharge seacock.
E
MPTYING
M
ARINE
H
EAD
H
OLDING
T
ANK
T
HROUGH
D
ECK
P
UMP
-
OUT
1). Remove the cap from the deck pump-out fitting located on the starboard gunwale.
2). Connect a vacuum hose from a pump-out station to the deck fitting and run until the tank is
empty. Replace the cap on the deck pump-out fitting.
See
“Marine Head” on page 8–24
for a layout diagram.
N O T I C E
Overboard discharge seacock must be secured in the closed position in accordance with the laws
in your boating area.
