M
AINTENANCE
AND
S
ERVICE
6–6
H
ARDWARE
/H
ARDTOP
F
RAME
/S
TAINLESS
S
TEEL
R
AILS
The hardware on your Grady-White is made of laboratory grade 316 stainless steel and needs
regular cleaning to maintain its “less staining” properties. The key to maintaining your stainless
steel is to keep it clean with a mild solution of soap and
FRESH
water.
M
AINTENANCE
P
ROCEDURE
F
OR
A
NODIZED
A
LUMINUM
C
OMPONENTS
(Lean Bars, Rod Holders, T-Top and Hardtop Frames, Outriggers, Etc.)
Due to the nature of anodized aluminum and the harsh exposure conditions of the marine envi-
ronment, it is important to follow a required maintenance procedure. Failure to follow a preventa-
tive maintenance procedure will most likely result in aluminum pitting.
These parts must be washed periodically with a very mild soap and water solution. Grady
White recommends washing with a mild soap (such as Ivory Liquid) after each use and every two
to three weeks if stored in an outside marine environment. Strong cleaners and soaps must not be
used; never use abrasive cleaners or products that contain chlorine bleach. These products can
remove the anodized coating.
Give special attention to the upper tubes of a hardtop or T-top frame. The area just below the
top is shielded by the canvas or fiberglass top and does not receive the natural rinse that rainwater
provides. Failure to thoroughly clean and maintain this area will allow contaminates that attack
the anodized aluminum to remain on the frame.
For maximum protection, coat parts with a non-abrasive metal protector. The best protectors
will displace moisture, remove contaminates, and leave a wax film protecting the anodized alumi-
num. Follow the application guidelines for the product you choose. A sample of one metal protec-
tor has been provided with your boat.
Metal Protectors:
Boeshield T-9
Aluma Guard
Premier Polish
PMS Products Inc.
Rupp Marine, Inc.
Aquatech
76 Veterans Dr.
Unit 1104761 Anchor Ave.
6726 Netherlands Drive, Suite 200
Holland, MI 49423
Port Salerno, FL 34992
Wilmington, NC 28405
800-962-1732 561-286-5300
800-853-7760
F
UEL
T
ANK
C
OMPARTMENT
The fuel tank storage area needs to be rinsed periodically, especially when used in a salt-water
environment. Dirt that accumulates in this area attracts salt and causes salt crystals to form on
your metal fuel tank. Salt crystals corrode most metal surfaces if left untreated over a period of
time. To help protect your tank from rust and corrosion, rinse the compartment with FRESH
water. Remove the access plates from the fuel tank lid and inspect this area for leaks or unsecured
lines.
The access plates on your fuel tank lids keep the fuel compartments sealed. Over time, the
opening and closing of these plates causes the o-rings to wear-out. Replace these o-rings as neces-
sary to maintain the watertight integrity of the plates.
C A U T I O N
Do not use abrasive cleaning products, pads, steel wool
or steel brushes. These products will damage the finish.
!
