29
DE
EN
FR
NL
ES
IT
DK
SE
NO
PL
UKR
HU
IMPORTANT!
• Handle the blade with care as it may be sharp and may lead to injuries.
• The sharp side must face forward into the direction of the perforated disc.
• Check to see that the opening is on the locating bolt in the
housing.
• Press on “Rev” when food has got stuck in the worm. Hold this button for
approx. 5 seconds.
• Never put your fingers into the feed chute. Always use the stuffer.
• Remove or place the worm housing only at standstill and the connecting
cable removed.
• If the unit switches off during the processing operation, it is overheated.
Disconnect the mains plug and let the unit cool down for 1 hour.
Mincing machine attachment
• Insert the worm housing and close the locking lever.
• Place the worm in the worm housing.
• Now place the blade.
• Place the requested perforated disc.
• Now screw on the ring nut.
• Insert the filling tray.
• Insert the plug into the socket, the unit is then in standby mode.
• Put a plate or bowl below the outlet.
• Place the food to be processed into the filling tray. Cut meat beforehand
into strips of about 2.5 cm in width and about 10 cm in length.
NOTE
If you do not press the Start/Stop button within 5 minutes, the unit will switch
off. To switch on the unit again, press the Start/Stop button.
• Press the Start/Stop button.
• Press the speed button. Here you have the choice between two speed
levels (1 and 2).
• Subsequently use the provided stuffer to push only.
• After finishing the mincing process, press the Start / Stop button.
• In order to disassemble the unit, pull the plug out of the socket, push the lo-
cking lever upward, remove the attachment and disassemble all individual
Summary of Contents for Fleischwolf FW 500
Page 2: ...2 ...
