34
• Remove the packaging parts.
• Remove any stickers on the unit (do not remove the type plate).
REQUIREMENTS ON THE INSTALLATION LOCATION
For safe and fault free operation of the unit, the following requirements of the
installation location have to be met:
• The unit has to be placed on a solid, flat, horizontal, and non-slipping surface
with a sufficient weight-carrying capacity.
• Make sure that the unit cannot topple over.
• Choose the location in such a way that children cannot reach the hot surface of
the unit or the supply lines.
• Do not place the appliance on hot surfaces, such as hotplates, or near them.
• Never use the appliance outdoors, and always keep it in a dry place.
• The unit is not designed for installation in a wall or a built-in cupboard.
• Do not set up the unit in a hot, wet or moist environment.
• The socket has to be easily accessible so that the power cable can be removed
easily in case of emergency.
ELECTRICAL CONNECTION
For safe and fault-free operation of the unit, the following requirements
have to be met during the electrical connection:
• Before connecting the unit, compare the connecting data (voltage and frequency)
on the type plate with those of your energy network. These details must corre-
spond so that no damage occurs to the unit. In case of doubt ask your trained
electrician.
• The socket has to be protected at least by a 10 amps circuit breaker.
• Make sure that the power cable is not damaged and is not laid across hot surfaces
or sharp edges.
• The connecting cable must not be stretched tightly.
• The electric safety of the unit is ensured only when it is connected to a socket
with protective conductor installed correctly. Operation on a socket without pro-
tective conductor is forbidden. If in doubt, let the house installation checked by
a trained electrician.The manufacturer shall not assume responsibility for damage
which has been caused by absent or interrupted protective conductor.
DESCALING REMINDER
The factory setting for the descaling function recall is set to 25 L. After the con-
sumption of descal setting, the descal reminder
start to flash. Only after a
complete decalcification the flashing goes off. Consult for this Chapter
„Decalcifi-
cation“page 40
.
The number of liters can be changed according to the use and hardness of your
water.
Summary of Contents for Marchesa
Page 167: ......
