Universal Slicer Tendenza T 6 / T 7 / T 9 / T 16
20
EN
important!
►
If possible, save the original
packing during the unit's
warranty period to be able
to properly pack the unit in
case of a warranty claim.
Requirements for the in-
stallation location
For safe and flawless operation
of the unit, the place of location
must meet these prerequisites:
■
The unit must be set up on a
firm, flat, level and non-slip
base that has sufficient load
bearing capacity.
■
Select the place of location so
that children cannot reach the
sharp blade in the unit.
Electric connection
Follow these instructions about
the electrical connection for safe
and flawless operation of the
unit:
■
Before connecting the unit,
compare the connection infor-
mation (voltage and frequency)
on the rating plate with those
of your electrical network. This
information must match to
avoid damage to the unit. If in
doubt, ask your electrician.
■
Make sure that the connecting
cable is not damaged. Do not
conduct it over hot surfaces or
sharp edges.
■
The connector cable must not
be pulled tight.
■
The electrical safety of the unit
is only ensured if it is connected
to a properly installed protective
conductor system. Operation
on a socket without a protec-
tive conductor is prohibited. If in
doubt, have the building instal-
lation checked by an electrician.
The manufacturer does not
assume any responsibility for
damages caused by a missing
or interrupted protective con-
ductor.
Summary of Contents for T16
Page 78: ......
Page 79: ......
Page 80: ...Gebr GRAEF GmbH Co KG Donnerfeld 6 59757 Arnsberg 24086 01 ...
