DE
EN
FR
ES
IT
NL
S
DK
NO
Pyc
CZ
SK
PL
Requirements for the installation location
For safe and flawless operation of the unit, the
place of location must meet these prerequisites:
The unit must be set up on a firm, flat, level and
non-slip base that has sufficient load bearing
capacity.
Select the place of location so that children
cannot reach the sharp blade in the unit.
Sources of hazards
The rotating blade can cut off body parts. Your
fingers, especially the thumbs, are endangered.
For this reason, never reach into the space
between the stop plate and the holder for the
material to be sliced as long as the stop plate
is not completely closed, i.e., is placed below
“0”.
Cutting
●
●
Swivel the machine feet out as far as they go
(1.1).
●
●
Push the slider on the underside of the
carriage together and turn the carriage over
(2.1).
●
●
Put the thumb protection into a horizontal
position (2.2).
●
●
Place the cutting goods on the carriage.
●
●
Adjust the desired cutting width by turning
the hand wheel (3.2).
●
●
Push the needed switch „Pulse“ or
„Permanent“ (3.1).
●
●
Press the cutting goods gently against the
stopper plate and lead the carraige evenly
against the blade (3.3).
●
●
After finishing the cutting process, turn off
the appliance (3.1).
●
●
Push the button on the side of the thumb
protection and flip it (6.1).
●
●
Push the slider on the underside of the
carriage together and flip it (6.2).
Important: Let the engine cool off after a
permanent usage of approx. 5 minutes.
