5
EN
before cleaning.
•
Make sure to use the unit only together with
the supplied base station. Never use the base
station for any other purpose.
•
Switch the unit on only after you have filled it
with water. Use cold water only.
•
The lid of the unit must always be firmly
closed.
•
Make sure the unit is switched off and is not
connected to the mains.
•
Do not use any aggressive or abrasive clean-
ing agents and do not use any solvents.
•
Do not scratch off stubborn soiling with hard
objects.
•
Do not rinse the unit off in water or immerse
it into water.
Before the first use
Read these operating instructions thoroughly
and keep them handy for referral later on.
This unit brings water to boil in a few minutes.
•
To clean the unit, first fill the unit with clear,
cold water and then boil it. Subsequently
pour away the water.
Unpacking
To unpack the unit, proceed as below:
•
Take the unit out of the carton.
•
Remove all pieces of the packing.
•
Remove any possibly extant labels on the unit
(do not remove the rating plate).
Requirements for the installation location
For safe and flawless operation of the unit, the
place of location must meet these prerequi-
sites:
•
The unit must be set up on a firm, flat, lev
-
el and non-slip base that has sufficient load
bearing capacity.
•
Make sure the unit cannot fall over.
•
Select the location so that children cannot
reach the hot surfaces of the unit and cannot
touch the cable.
