13
Troubleshooting
Most problems you encounter with your
TV can be
corrected by consulting the following troubleshooting list.
No picture, no sound
1. Check if the fuse or circuit breaker is working.
2. Plug another electrical device into the outlet to make
sure it is working or turned on.
3. Power plug is in a bad contact with the outlet.
4. Check the signal source.
No color
1. Change the color system.
2. Adjust the saturation.
3. T ry another channel. Black-white program may be
received.
Remote control does not work
1. Change the batteries.
2. Batteries are not installed correctly.
3. Main power is not connected.
No picture, normal sound
1.
Adjust the brightness and contrast.
2. Broadcasting failure may happen.
Normal picture, no sound
1. Press the Vol+ button to increase volume.
2. Volume is set to mute, press the mute button to
restore sound.
3. Change the sound system.
4. Broadcasting failure may happen.
Unorderly ripples on the picture
It is usually caused by local interference, such as cars,
daylight lamps and hair driers. Adjust the antenna to
minimize the interference.
Blank screen in VGA mode
Perhaps the TV can not recognize the resolution set by
the PC. Suggest to change to the best resolution or
other standard resolutions of the Windows system.
Snowy dots and interference
If the antenna is located in the fringe area of a television
signal where the signal is weak, the picture may be
marred by dots. When the signal is extremely weak,
it may be necessary to install a special antenna to
improve the reception.
1. Adjust the position and orientation of the indoor/
outdoor antenna.
2. Check the connection of antenna.
3. Fine tune the channel.
4. T ry another channel. Broadcasting failure may
Ignition
Black spots or horizontal streaks appear, or the picture
flutters or drifts.
This is usually caused by interference
from car ignition system, neon lamps, electric drills, or
other electrical appliance.
Ghost
Ghosts are caused by the television signal following
two paths. One is the direct path, the other is
reflected from tall buildings, hills, or other objects.
Changing the direction or position of the antenna
Radio frequency interference
This interference produces moving ripples or
diagonal streaks, and in some case, loss of
Find out and remove the radio interference source.
If the TV is crashed
1. Press the Power button to turn off TV,then press the
Power button again to reset
TV.
2. Unplug the power cord, then press the Power button
to reset T V.
Note: If these 2 methods can not be resolved, please
contact the after-sales to solve.
Base Installation
To fix the double support base on the unit by screws,
the installation is completed.
2
1
Screw x 4
Base x 2
Note: Illustrations below are provided for reference
only and may differ from actual product appearance.
happen.
may improve the reception.
contrast in the picture.
Chapter 4
Other Information
