GD_6700-6800-INS-LAB-RevA21 • Regency 6700 / 6800 User Manual
18
RECLINER
ADJUSTING THE BACK ANGLE
Spring button
Release lever
Pushbar
HEADREST
1. See picture above: to adjust the back angle, grasp both ends of pushbar securely and
simultaneously pull up on both release levers (use your hands to squeeze pushbar ends and
release levers together).
2. Gently lower or raise the back to the desired height.
3. Release the levers.
WHEEL LOCKS
ADJUST WHEEL LOCKS
Tools required:
7
/
16
" wrench
As a result of tire wear, wheel locks may need adjustment to prevent the rear wheels from turning
when the wheel locks are engaged.
To adjust wheel locks:
1. Use a
7
/
16
" wrench to loosen the two locknuts (shown at right) until the lock slides on the
frame.
2. Place the wheel lock in the locked position and slide it into contact with the tire.
3. Place the wheel lock in the unlocked position and slide it
3
/
8
" closer to the tire.
4. Use a
7
/
16
" wrench to tighten the two clamp bolts and engage the lock to check the fit. The
lock should indent the tire at least
3
/
8
". Tighten clamp bolts securely to eliminate wheel lock
movement on frame.
WARNING: Ensure wheel locks are adjusted so that they lock in place appropriately before
occupying or operating wheelchair.
