LX_FR577RG-INS-LAB-RevJ21 6
3. Remove cardboard shipping retainers
and tape from around gas spring cylinder.
Rotate the gas spring hinge section so
that it is perpendicular to the upholstered
back, as shown at right.
4. Remove upholstered side panels
from frame: Depress the two
push buttons located on the
lower sides of frame. Pull side
panel gently away and down
from frame. There are tabs on
the frame underneath the
armrest that hold the side panel
in place.
5. Lift the upholstered back from the
sides and place it horizontally with
the upright back tubes resting on
the recliner frame.
6. Align the holes on the
upright back tubes of the
upholstered back with the
holes on the seat frame.
Place the
3
/
8
" diameter
clevis pins through the
mounting holes in the frame
and back as shown at right.
7. Secure the two clevis pins
by placing a large cotter
pin through the hole in the
clevis pin (one for each
side) as shown at right.
push button
panel tabs
side panel
clevis pin
cotter pin
Remove Side Panel
Clevis Pin and Cotter Pin
Align Holes
Place Clevis Pins
Place Cotter Pin
Cotter Pin
gas spring hinge
Rotate HInge
