LX_FR577RG-INS-LAB-RevJ21 7
8. Raise the upholstered back to vertical position.
Tuck the plastic skirt at rear of upholstered
back behind cross brace of seat frame. Align the
hinges at the bottom of the gas spring with
the holes in the U-brackets on the seat frame
cross brace. While holding the back in position
with one hand, secure the gas spring hinge to
the U-bracket by placing the
5
/
16
" diameter
clevis pins through the U-bracket and hinge
with the other hand.
9. Secure the clevis pin by placing the ring cotter
pin through the hole in the clevis pin as shown
at right.
10. Replace side panels:
Insert side panel into recliner
frame by locating the tabs
underneath the armrest.
Make sure side panel is
properly aligned and that the
top edge is behind the locking
tabs. Press side panel into
frame sides. Make sure that
both push buttons are
protruding into side panel to
ensure side panel is locked in
place.
Place Clevis Pins
Place Cotter Pins
push button
panel tabs
side panel
Replace Side Panel
