765041782
Rev. 002
12
Operating the product
Connect the product to the socket. This is done by mounting the accompanying power
cord first as shown in Fig. 4, and then subsequently connecting the cord to the socket.
To switch the product on and set the desired temperature for the cabinet, the uppermost
panel must be flipped up and held in that position.
NOTE:
Note that the panel does not stay up by itself, but rather must be held up
when it is opened.
Fig. 6
When the product has been connected to the power supply, but not switched on yet (in
standby), this is indicated by a small control lamp
which is the only one lit in the
lower right corner of the display.
To switch the product on, press
for approx. 3 seconds. During start-up, the
control lamp
will blink until the product is on.
The display will show the current temperature in the product. This also serves to indicate
that the power supply is connected to the product.
The product is switched off in the same manner as it is switched on. By pressing
for approx. 3 seconds.
To switch on and off both the interior light in the product and the light in the display box,
above the door, use the switch placed immediately to the left of the controls behind the
display box. To gain access to this switch, rotate the display box upwards as shown in
Fig. 6.
