Repair Manual MSG 90.6PG Commercial Vehicles, Omnibuses – November 2017
Material no. 1153450_c
3.11 Bowden pull wire and lever for vertical shock absorber adjustment –
removal and installation
Page 4 of 7
REMOVAL / INSTALLATION
TABLE OF CONTENTS
7 Take off the Bowden pull wire (1) at
the fork (5) and remove the
compression spring (6).
8 If the bearing (8) is defective:
8.1 Pull off the adjusting lever (4) at the
pin of the vertical shock
absorber (7).
8.2 Loosen the lock washer (9) at the
axle (10).
8.3 Pull off the bearing (8) at the
axle (10).
9 Mark the fixing position of the Bowden
pull wire (1) at the holder (11) and
detach the Bowden pull wire (1) at the
holder (11).
Installation note:
Hang the Bowden pull wire (1) into the
holder (11) according to the marking.
3
2
12
1
10
6
9
4
7
1
1
11
5
6
8
7
1
9
10
4
5
8
2182
4
10
9
7
11
6
5
8
1
1
