Page 2 of 6
W
ARNING
Turn appliance OFF and allow to cool before installing or servicing. DO NOT connect
110-120 VAC wiring to the millivolt gas control valve. The remote operator must be installed
exactly as outlined in these instructions. Read all instructions completely before attempting
installation. Follow instructions carefully during installation. Any modification of
components will void the warranty and may cause a fire hazard.
Transmitter:
Installing Batteries
:
The remote transmitter uses two (2) “AAA” batteries. To install batteries:
1.
Press down the battery door and remove the battery door.
2.
Install uses two (2) “AAA” batteries as indicated on transmitter.
3.
Close the battery door by snapping in place.
4.
The batteries should be replaced when the low battery indicator display in LCD.
5.
When both batteries are installed, the transmitter will initialize for 1 seconds and then is ready for use.
LEARNING TRANSMITTER TO RECEIVER
1.
The transmitter privacy (DIP) Switches are preset at the factory. Setting the 4 bits DIP Switches on
transmitter to select a security code.
2.
Put the receiver slide switch to “
RS”
location. Using a small screwdriver or end of a paper clip gently press
and hold the
‘LEARN ‘
button on the receiver to accept the transmitter security code upon initial use, when you
release the
LEARN
button the receiver will emit an audible 3 “beep” sounds
3.
After the receiver emits 3 “beep” sounds. Press the transmitter “ON “or “OFF” button and release at once.
The receiver will emit several beeps indicating that the transmitter’s code has been accepted into the receiver.
4.
If you are unsuccessful in matching the security code on the first attempt repeat step 1-3
Transmitter
Dip Switch (Default as below, can be setting by user)
Receiver
KEY SETTINGS
1.
ON
- - ------
Turns appliance ON.
2.
OFF
- -----Turns appliance OFF.
3. TIMER
- --Changes unit from manual mode to timer mode.
4.
SET
- ------Adjusts timer setting.
WA
R
NI
NG
Do not use two (2) or more remote-control systems in the same area with the same dip switch
settings, as they will communicate with each other. This may cause the appliances to
malfunction.
