Page 5 of 6
Connect one wire from the remote receiver to the TH terminal on the gas valve Connect the other wire from the
remote receiver to the TH/TP terminal on the gas valve
Slide Switch
:
1.
ON position
: the system will remain on until the slide switch is placed in the OFF or REMOTE position.
2.
REMOTE position
: the system will only operate if the remote receiver receives a signal from the transmitter.
3. OFF position
: the system is off.
The slide switch should be placed in the OFF position if you will be
away for an extended period of time.
If the remote receiver is mounted out of children’s reach, the OFF
position also functions as a safety device by both turning the system off and rendering the receiver inoperable.
Testing Your New Remote System
1. Light your gas appliance following the appliance lighting instructions that come with the appliance. Confirm
that the pilot light is on; it must be in operation for the remote control to operate the main gas valve. Appliance
control knob must be in the ON position. Appliance ON/OFF switch must be in ON position.
2. Slide the 3-position button on the remote receiver to the ON position. The main gas flame should ignite.
3. Slide the button to OFF. The flame should extinguish (the pilot light will remain on).
4. Slide the button to REMOTE (the center position), then press the transmitter to turn the system to ON. The
main gas flame should ignite.
5.
Press the transmitter to turn the system to OFF. The flame should extinguish (the pilot light will remain on).
TROUBLESHOOTING
