2
Grand Canyon Gas Logs---3435 E. Atlanta Ave---Phoenix, AZ 85040
IMPORTANT INFORMATION
WARNING: This appliance assembly contains burner orifices specifically for the input gas specified on the burner
and box, as well as the Btu rating specified in this manual. Modifying or failure to use the factory orifice may
cause property damage, personal injury or loss of life.
Read these instructions completely before installing and using Grand Canyon Gas Log system.
1.
Gas type will be indicated on the burner and the box. Do not use a natural gas burner with propane or a
propane burner with natural gas.
2.
The installation, provisions for combustion, and ventilation air must conform to the National Fuel Gas
Code,
ANSI Z223.1/NFPA54
, or the
CSA B 149.1
, National Gas and Propane Installation Code.
3.
For warranty to be valid gas log sets must be installed by a NFI certified or other qualified professional
installer.
4.
This appliance must be installed only in a solid-fuel burning fireplace with a working flue and constructed
of non-combustible materials. Solid fuels are not to be burned in a fireplace where a decorative appliance
has been installed.
5.
A permanent free opening must be provided by either the fireplace chimney or chimney damper to vent
carbon monoxide and other flue gases. Any chimney damper must be fixed in a manner, which will
maintain the permanent free opening at all times. Use the table at the bottom of this page to determine
the minimum permanent free opening based on chimney height and the appliance Btu rating.
6.
A fireplace screen must be in place when the appliance is operating and, unless other provisions for
combustion air are provided, the screen shall have an opening(s) for introduction of combustion air. With
use of glass doors, doors must be open while the appliance is burning to assure proper ventilation.
7.
The minimum inlet supply pressure for the purpose of input adjustment is 5.0 inches (natural gas) 8.0
inches (propane) in water column. The maximum inlet supply pressure is 10.5 inches (natural gas) 13.0
inches (propane) in water column.
8.
The appliance and its individual shut-off valve must be disconnected from the gas supply piping system
during any pressure testing of that system at test pressures in excess of ½ psig (3.5kPa). The appliance
must be isolated from the gas supply piping system by closing its individual manual valve during pressure
testing equal to or less than ½ psig (3.5kPa).
9.
The appliance area is to be clear and free from combustible materials, gasoline and other flammable
vapors and liquids.
10.
Do not use this appliance if any part has been under water. Immediately call a qualified service technician
to inspect the appliance and to replace any gas control which has been under water.
FIREPLACE SIZE REQUIREMENTS
Burner
Size
Min. Fireplace Dimensions
BTU
Width
Depth
Height
Front
Rear
NAT.
L.P.
18”
20”
18”
12”
14”
40K
35K
24”
25”
23”
12”
14”
52K
49K
30”
30”
28”
14”
14”
64K
64K
Kiva Burner Size Chart
Burner Size
Front Width
Depth
Back Width
Height
18”
12”
9”
6”
6”
24”
18”
9”
11”
6”
30”
21”
9”
14”
6”
IMPORTANT
For all valves, the air MUST be purged from the gas line before the pilot will light and burn properly. The
time needed to purge will depend on the length of the gas line to the unit and the amount of time since the
unit or gas line was last used. It may take several minutes before all the air is purged and the pilot will light
and burn properly. Follow the LIGHTING INSTRUCTIONS section in this manual.
