6
Grand Canyon Gas Logs---3435 E. Atlanta Ave---Phoenix, AZ 85040
FOR YOUR SAFETY READ BEFORE LIGHTING
“WARNING –
If you do not follow these instructions exactly,
a fire or explosion may result causing property damage,
personal injury or loss of life.”
A.
This appliance has a pilot which must be
lighted by hand.
B.
BEFORE LIGHTING
smell all around the
appliance area for gas. Be sure to smell
next to the floor because some gas is
heavier than air and will settle on the
floor.
WHAT TO DO IF YOU SMELL GAS:
1.
Do not try to light any appliance.
2.
Do not touch any electric switch; do not
use any phone in your building
3.
Immediately call your gas supplier from a
neighbor’s phone. Follow the gas
supplier’s instructions.
4.
If you cannot reach your gas supplier, call
the fire department.
C.
Use only your hand to push in or turn the
gas control knob. Never use tools. If the
knob will not push in or turn by hand,
don’t try to repair it, call a qualified service
technician. Force or attempted repair may
result in a fire or explosion
D.
Do not us this appliance if any part has
been under water. Immediately call a
qualified service technician to inspect the
appliance and to replace any part of the
control system and any gas control, which
has been underwater.
LIGHTING INSTRUCTIONS
1.
STOP! Read the safety information above on this
label.
2.
Push in gas control knob slightly and turn clockwise
to “
OFF”
NOTE: Knob cannot be turned from “PILOT” to “OFF”
unless knob is pushed in slightly. Do not force.
3.
Wait five (5) minutes to clear out any gas. If you
then smell gas, STOP! Follow “B” in the safety
information above. If you don’t smell gas, go to
next step.
4.
Find pilot – follow metal tube from the gas control
behind the burner.
5.
Turn knob on gas counter-clockwise to arrow in the
center of the knob.
6.
Push in control knob all the way and hold in.
immediately light the pilot with a match. Continue
to hold the control knob in for about one minute
after the pilot is lit. release knob and it will pop
back up. Pilot should remain lit. If it goes out,
repeat steps 3-7
If knob does not pop up when released, stop and
immediately call your service technician or gas
supplier.
If the pilot will not stay lit after several tries, turn
the gas control knob to “
OFF”
and call your
service technician or gas supplier.
7.
Turn gas control knob counterclockwise to “
ON”
TO TURN OFF GAS TO APPLIANCE
1.
Turn knob clockwise from “
ON
” position to the center arrow position. Push in the gas control knob
slightly and turn clockwise to “
OFF”.
Do not force knob.
